 |
VK-NB
VIROCK
1. Basic machine technical data:
| Machine normal width: | 1400-3800mm | Working width range: | 1200-3600mm
|
| Heating source of the dryer: | nature gas / oil / electricity / steam
| Width adjustment range: | 700-3600mm
|
Chambers quantity
| 2-10 | Temperature of chambers: | 100-230℃
|
| Fabric held by: | clip/pin/combined
| Air pressure: | above 0.5mpa |
| Overfeed range: | -10% to 30%
| Installed power: | It depends |
2. Machine Operation:
Start by entering the fabric through the open width section. Use a device to ensure the fabric is centered properly.
Then, pass it through a padder dipping and optionally straighten the weft automatically. Adjust the lower overfeeding and
expand the fabric using screws. Increase the upper overfeeding and detect the edges. Attach pins to secure the fabric
and apply gum and moisture using a specialized device. Move the fabric through chambers for heat setting and cool
it with air. Cut the edges and remove any excess fabric using a suction system. Finally, finish the process by plaiting
the fabric.
3. Benefits of the Machine:
Customizable to meet customer needs. Rapidly raises room temperature to desired level, minimizing wasted time and increasing productivity. The drying chamber is constructed with highly insulating material that is 150mm thick, effectively reducing heat loss and ensuring optimal stentering results. Even at elevated temperatures, the machine generates ample air volume and pressure, allowing hot air to quickly penetrate the fabric through the nozzles, resulting in a flawless stentering effect.
1. Basic machine technical data:
| Machine normal width: | 1400-3800mm | Working width range: | 1200-3600mm
|
| Heating source of the dryer: | nature gas / oil / electricity / steam
| Width adjustment range: | 700-3600mm
|
Chambers quantity
| 2-10 | Temperature of chambers: | 100-230℃
|
| Fabric held by: | clip/pin/combined
| Air pressure: | above 0.5mpa |
| Overfeed range: | -10% to 30%
| Installed power: | It depends |
2. Machine Operation:
Start by entering the fabric through the open width section. Use a device to ensure the fabric is centered properly.
Then, pass it through a padder dipping and optionally straighten the weft automatically. Adjust the lower overfeeding and
expand the fabric using screws. Increase the upper overfeeding and detect the edges. Attach pins to secure the fabric
and apply gum and moisture using a specialized device. Move the fabric through chambers for heat setting and cool
it with air. Cut the edges and remove any excess fabric using a suction system. Finally, finish the process by plaiting
the fabric.
3. Benefits of the Machine:
Customizable to meet customer needs. Rapidly raises room temperature to desired level, minimizing wasted time and increasing productivity. The drying chamber is constructed with highly insulating material that is 150mm thick, effectively reducing heat loss and ensuring optimal stentering results. Even at elevated temperatures, the machine generates ample air volume and pressure, allowing hot air to quickly penetrate the fabric through the nozzles, resulting in a flawless stentering effect.
